GORMAN-RUPP 83B3-B Manuals & User Guides User Manuals, Guides and Specifications for your GORMAN-RUPP 83B3-B Water Pump. Database contains 1 GORMAN-RUPP 83B3-B Manuals (available for free online viewing or downloading in PDF): Installation, operation and maintenance manual. In no event shall The Gorman-Rupp Company be liable for con- sequential damages or contingent liabilities arising out of the fail- ure of any Gorman-Rupp pump or parts thereof to operate prop- erly. This manual is also suitable for: 12c 12b 12d 13a 13c 13e. GORMAN‐RUPP PUMPS www.grpumps.com 1981 Gorman‐Rupp Pumps Printed in U.S.A. INSTALLATION, OPERATION, AND MAINTENANCE MANUAL WITH PARTS LIST 0 SERIES PUMP MODEL 03H1-GR. Mass effect 3 spectre weapons. Register your new Gorman‐Rupp pump online at www.grpumps.com Valid serial number and e‐mail address required.
PA6C60-4045T FT4 Priming Assisted Pump
PA6C60-4045T FT4 Specifications | |
---|---|
Suction | 150 mm |
Discharge | 150 mm |
Solids Handling | 76 mm |
Casing | Ductile Iron |
Impeller/Rotor | Ductile Iron |
Seal Material | Silicon Carbide |
Flange | ANSI |
Drive Type | Diesel Engine |
Unit Weight | N/A |
Disclaimer:
Consult your Gorman-Rupp distributor for detailed information concerning your model. Parts lists can sometimes vary from pump to pump. Your serial number is critical in determining the correct parts and service requirements for your pump. Information on this page is provided for reference only.
Pump Sales
(419) 755-1933
Parts Sales
(419) 755-1280
International Sales
(419) 755-1352
An error occurred. Please refresh the page or contact an admin.
An error occurred. Please refresh the page or contact an admin.
OM-05136
T SERIES
PAGE B - 1
INSTALLATION
INSTALLATION - SECTION B
Review all SAFETY information in Section A.
Since pump installations are seldom identical, this
section offers only general recommendations and
practices required to inspect, position, and ar
Learning group leadership an experiential approach pdf download. range the pump and piping.
Most of the information pertains to a standard stat
ic lift application where the pump is positioned
above the free level of liquid to be pumped.
If installed in a flooded suction application where
the liquid is supplied to the pump under pressure,
some of the information such as mounting, line
configuration, and priming must be tailored to the
specific application. Since the pressure supplied
to the pump is critical to performance and safety,
be sure to limit the incoming pressure to 50% of
the maximum permissible operating pressure as
shown on the pump performance curve.
For further assistance, contact your Gorman‐Rupp
distributor or the Gorman‐Rupp Company.
Pump Dimensions
See Figure 1
for the approximate physical dimen
sions of this pump.
OUTLINE DRAWING
NOTE: OPTIONAL SUCTION & DISCHARGE SPOOL FLANGES AVAILABLE
Gorman Rupp Pump Parts Manual
Figure 1. Pump Model T2A3‐B
PREINSTALLATION INSPECTION
The pump assembly was inspected and tested be
fore shipment from the factory. Before installation,
inspect the pump for damage which may have oc
curred during shipment. Check as follows:
a. Inspect the pump for cracks, dents, damaged
threads, and other obvious damage.
b. Check for and tighten loose attaching hard
Gorman Rupp T Series Manual
ware. Since gaskets tend to shrink after dry